How to Jump Start a Toyota Prius (Gen II: 2004-2009)

I love Costco. I was at a Costco tire center earlier today to get my tires rotated, rebalanced, and the air pressure checked. The mechanic noticed there was a nail in my tire and patched up my tire for free. Awesome. The mechanic tried a few times to start my car and when it wouldn’t start, he asked me if there was a secret to starting my car. I’m thinking “Fuck, did the HV battery finally eat shit?” My car has over 234K miles and will eventually need a new HV battery. Yes, I live dangerously.

The mechanic suggested the issue might be related to the keyfob being low on battery (WRONG). None of the door controls were working and dash was displaying a “check engine” light. When the mechanic turned on the interior light, I noticed it was extremely dim then realized he left my car on IG-ON mode (Power button is Orange) which inevitably drained my 12V battery. As a sanity check, I checked my ScanGauge II for any diagnostic/trouble codes. No stored codes. **Phew** Ok, so now my car needs a jump start.

Here’s a quick tutorial on how to jump start your Prius safely.

Some advice:

ALL PRIUS OWNERS SHOULD OWN AND CARRY A PORTABLE JUMP STARTER IN THEIR CAR AT ALL TIMES. Never get a jump start from another car – If you make a mistake, you will very likely destroy the Prius inverter which will result in a low four-figures repair bill. Read this post if you think your inverter is fried.

I’ve owned this since the early 2000’s. It’s also useful during power outages – it has a work light and two 12-volt cigarette lighter ports (useful for charging your cell phone and other electronics).

Although the 12V battery is located in trunk, the jumper mounts are located in the front of the car. Pop open the car front hood and look for a black box at the top right of the engine bay. Remove the black cover, then a red cover to expose the Positive (+) terminal.

On the portable jump starter, make sure the Booster Cable ON/OFF switch is set to “OFF” position. On the car, locate the clamp points which are circled in the left photo. First, attach the red clamp to the Positive (+) terminal, then the black clamp to the nut shown in the photo. We are using the nut as the negative (-) terminal.

Once the clamps are connected, the Reverse Polarity Indicator LED on my jump starter will light up GREEN. This means the polarity is correct, otherwise, it will illuminate RED and sound an alarm to indicate the clamps are reversed (this is bad).

After verifying the connections are correct (i.e. GREEN light) go ahead and toggle the Booster Cable switch to “ON” and hop into the driver’s seat to start the car. Make sure all car lights (headlights & interior lights) are “OFF” then start the car as you normally would… with the foot pressing down on the brake pedal while pressing the power button.

It’s a bit anti-climatic when the car does start up. Look on the dash for the “READY” indicator — if this is showing, congratulations, you’ve successfully jumped started your Prius. YAY!

Now, let’s disconnect the jumper pack.
1) Leave your car running on when disconnecting the jumper clamps.
2) Toggle the Booster Cable switch to “OFF”
3) Disconnect the jumper cables starting with black then red. Don’t let the clamps touch each other or any part of the car.
4) Drive the car around for 20-30 minutes to recharge your battery.

If the jump-start fails, there are likely some other issue that needs to be addressed… the issue would have likely generated a diagnostic/trouble code (hence, why I checked first before jumping the car).

Don’t forget to recharge the portable jump starter after use!